SG250 Owner’s and Service Manual
www.CSCMotorcycles.com
9
Controls
The motorcycle is operated with the ignition switch, the instruments, the throttle, the clutch, the front
brake lever, and the rear brake lever. You can start your motorcycle using either the kick starter or the
electric starter. Locations for these items are shown in the photos above and below. Operating the
motorcycle is explained below.
Ignition Lock and Fork Lock
The motorcycle key operates the ignition lock. Insert the key and
turn it to the right to turn the ignition on. The ignition switch also
operates the parking light.
If you need additional keys, CSC stocks the key blanks for the SG250
motorcycle. Please call us at 909 445 0900 if you need to make
additional keys for your motorcycle.
Fork Lock
The fork lock is located on the left side of the frame near the
steering yoke. To lock the forks, turn the forks all the way to the left.
Insert the ignition key, rotate it, and withdraw the key.
Warning! Do not attempt to ride the motorcycle with the forks in
the locked position.
Instruments
SG250 instrumentation includes a speedometer, a
tachometer, an odometer, a fuel gage, turn signal
indicators, a high beam indicator, and a gear
indicator.
Left and Right Handlebar Switchgear
Left handle switchgear includes the passing light, the high beam/low beam switch, the turn signals, and
the horn. The high beam/low beam flash switch momentarily activates the motorcycle’s high beam
To Next Page
Loading...
