CSC SG250 - Brakes and Drivetrain Service

SG250 Owner’s and Service Manual
www.CSCMotorcycles.com
20
Item
Cause
Symptom
Vehicle Effect
Maintenance Action
Sidestand
Deformation or
fracture
Sidestand cannot
return
Noise and compromised
parking
Correct or replace the
side support
Left or right
rear panel
Impact
Panel damaged
Compromised
appearance
Replace or repair the
panel
Left or right
tank panel
Impact
Panel damaged
Compromised
appearance
Replace or repair the
panel
Front fender
Impact
Deformation or
breakage
Compromised
appearance
Replace the front
fender
Rear fender
Impact
Deformation or
breakage
Compromised
appearance
Replace the rear
fender
Seat cushion
Impact
Seat cushion
damaged
Riding comfort
decreases
Replace the seat
Front footpeg
Impact
Deformation or
breakage
Compromised driving
safety
Replace the footpeg
Rear footpeg
Impact
Deformation or
breakage
Compromised driving
safety
Replace the footpeg
Rearview
mirror
Impact
Deformation or
breakage
Compromised driving
safety
Replace the rearview
mirror
Rear rack
Impact
Deformation
Compromised
placement of items
Replace the rear rack
Brakes
This section of the SG250 Owner’s and Service Manual covers the following topics:
 Master cylinder locations
 Inspecting and replacing the brake pads
 Inspecting and replacing the brake disk
 Flushing and replacing the brake fluid
 Bleeding the brakes
 Brake troubleshooting
Master Cylinder Location
The front brake master cylinder is located on the right
handlebar. It has a fluid level indicator on the master
cylinder that shows the “low” level. When the front master
cylinder fluid level is at the low mark, it is an indication that
the front brake pads should be replaced. Do not rely only
on this indication; you should check the pad thickness
regularly and replace them when they are worn below
acceptable limits (to be described below).