EasyManua.ls Logo

CSC SG250 - Swingarm and Rear Suspension

CSC SG250
111 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
SG250 Owners and Service Manual
www.CSCMotorcycles.com
44
Remove the fork seal from the lower fork leg.
If a fork seal leaks because it was damaged by grit or some other attributable cause, you need to replace
only the leaking seal. If the seal(s) leak due to age-induced degradation, you should to replace the seals
on both fork legs.
Please call CSC at 909 445 0900 for a discussion on which oil best suits your needs and to order
replacement oil.
Warning! Do not operate the motorcycle without fork oil.
Caution! Do not overfill the forks, or you may blow out the fork seals.
Swingarm and Rear Suspension
This section of the Owners and Service Manual addresses swingarm and rear suspension
maintenance. Note that the photos in this section of the SG250 Service Manual show the TT250
motorcycle. The SG250 and TT250 motorcycle are similar in design.
The first step is to safely elevate the rear end of the
motorcycle. We use a motorcycle jack; any suitable lift
method will work.
Remove the rear wheel. Rear wheel removal is covered in
the SG250 Wheel Removal section of the Owner’s and
Service Manual.

Table of Contents

Related product manuals