CSC SG250 - Page 45

SG250 Owner’s and Service Manual
www.CSCMotorcycles.com
45
Remove the nut and bolt that attaches the rear shock
absorber to the swingarm.
Rotate the lower portion of the rear shock absorber to clear
the swingarm mounting bracket, and remove the bushing
from the rear shock absorber.
Unbolt the nuts securing the swingarm pivot axle.
There will be dust caps/washers on the frame between the
swingarm axle nuts and the frame. Remove these and set
them aside.
Pull the swingarm pivot axle out of the frame.