EasyManua.ls Logo

CSC SG250 - Page 61

CSC SG250
111 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
SG250 Owner’s and Service Manual
www.CSCMotorcycles.com
61
Pour 1.2 liters of oil into the oil fill port on the right side of
the motorcycle.
1.2 liters is about 1.3 quarts. The best way to get the right
amount of oil in the engine is to pour in a quart, and then
pour the last 0.3 quarts in at a slow rate keeping an eye on
the oil viewing port (on the right side of the engine). When
you have 1.2 liters, the oil level will be between the L and H
marks when the bike is vertical (off the sidestand), as you
see here.
Start the engine, let the bike warm up, and then check the
oil again. You can also check the oil with the dipstick. The
proper way to do this is to let the engine warm, shut the
ignition, remove the dipstick and wipe it clean, wait one
minute, hold the bike vertical, and then reinsert the dipstick
without screwing it into the engine.
Withdraw the dipstick and check the oil level. It should be at
the upper level of the cross-hatched area on the dipstick (the
oil should come up to the upper red arrow shown in the
photo below).
This is the proper level for the engine oil.

Table of Contents

Related product manuals