SG250 Ownerās and Service Manual
www.CSCMotorcycles.com
77
Remove the o-rings from the float bowl and the carburetor
body.
Clean the carburetor interior and exterior surfaces using a
suitable solvent.
Use a q-tip to clean the interior of the float valve body.
Assembly is the reverse of disassembly.
When reinstalling the jets and the jet carriers, do not
overtighten them or you may strip the aluminum carburetor
body threads.
When installing the brass bushing that faces the underside of
the main jet, make sure the square end faces away from the
main jet carrier and the beveled end faces the main jet
carrier.
When you insert this piece in the carburetor body, it is not
likely to fully seat or go in straight without assistance. We
use an Allen wrench to make sure this bushing is properly
guided into its seat.
To Next Page
Loading...
