Cub Cadet EX2900 - Inspecting the Battery; Removing and Installing the Battery; Removing the Battery

15-3
15. SERVICING THE ELECTRICAL SYSTEM
Ex2900 / 3200 Operator's Manual
■ Inspecting the Battery
The battery used on your tractor is a maintenance-free
design. Do not add electrolyte or recharge it.
When the engine is off, measure the voltage on the
battery across the positive and negative posts. If the
reading is 11 V or lower, replace the battery with a new
one.
■ Removing and Installing the Battery
(A) Black negative (–) cable
(B) Negative terminal
(C) Positive terminal cover
(D) Red positive (+) cable
(E) Threaded rods
(F) Bracket
1. Removing the Battery
1. Park your tractor safely.
2. Raise the hood.
3. Disconnect the black negative (–) cable from the
battery first.
4. Pull back the red positive terminal cover and
disconnect the red positive (+) cable.
5. Remove the nuts, threaded rods and bracket.
Remove the battery hold-down assembly.
6. Remove the battery.
3013720
(A) (B) (C) (D)(E) (E)
(F)