14-5
14. PERIODIC SERVICE
Ex2900 / 3200 Operator's Manual
■ Inspecting the Transmission Oil Level
1. Park the tractor safely. Allow the tractor to cool off for
at least 1 hour.
IMPORTANT: Avoid damage.
●Prevent dirt and other contaminants from entering the
transmission. Clean the area around the dipstick before
removing it.
●NEVER overfill the transmission.
2. Remove the dipstick.
3. Read the oil level on the dipstick. The oil level should
be between the high and low levels on the dipstick.
4. When the oil level is low:
Clean the area around the oil fill cap, then remove the
fill cap from the transmission housing.
Add Cub Cadet Hydraulic / Transmission Fluid through
the fill port until the oil level is appropriate.
5. Reinstall and tighten the oil fill cap. Reinsert the
dipstick.
(A) Dipstick
(B) Oil fill cap
■ Checking the Wheel Bolt Tightening Torque
Avoid injury:
●To prevent possible roll-over of the tractor, check
the rim, hub and wheel bolts at regular intervals.
Service Intervals
●Regular Interval : Before day's operation
●After adjusting the wheel tread or replacing the tires:
After 1 hour of operation and every 4 hours after that
until appropriate tightening torque values are reached
and maintained.
WARNING
3013705
(A)
(B)
3013741
(A)
To Next Page
Loading...
