Cub Cadet EX2900 - Inspection Procedure for Safety Interlock System

14-13
14. PERIODIC SERVICE
Ex2900 / 3200 Operator's Manual
1. Park the tractor safely.
2. Allow the engine to cool off for several minutes before
refueling.
3. Remove the fuel tank cap.
4. Fill the tank with fresh fuel to the bottom of filler neck.
IMPORTANT:
●NEVER overfill the fuel tank.
5. Reinstall the fuel tank cap.
(A) Fuel tank cap
(B) EPA regulation label CY114110-07760
EPA REGULATION
USE LOW SULFER FUEL OR ULTRA LOW
SULFER FUEL ONLY
■ Inspection Procedure for Safety Interlock System
To avoid personal injury, do as follows:
●Read the “Safety Precautions” at the head of this
manual.
●Read the danger, warning and caution statements
on the safety alert decals on the tractor.
●To avoid possible poisoning from exhaust fumes,
NEVER operate the engine in an enclosed place that
lacks adequate ventilation.
●NEVER start the engine while standing on the
ground. ALWAYS start the engine from the
operator’s seat.
●Before starting the engine, ALWAYS set all the
levers to the “NEUTRAL” positions and the Power
Take Off (PTO) engagement lever to the “OFF”
position.
Check the following points to be sure that the machine is
in the normal state and ready to start.
If a fault is detected on the machine, do not operate the
machine and contact your local Cub Cadet Yanmar dealer
for technical assistance.
Before actuating the Power Take Off (PTO) engagement
lever, fully depress the clutch pedal and disengage the
clutch.
CAUTION
2010682
(A)
(B)
EPA REGULATION
USE LOW SULFER
FUEL OR ULTRA LOW
SULFER FUEL ONLY
(B)