12-1
12. TIRES, WHEELS AND BALLAST
Ex2900 / 3200 Operator's Manual
12.
TIRES, WHEELS AND BALLAST
NEVER attempt to mount a tire on a rim. Contact a
reputable tire repair facility.
ALWAYS keep the tires inflated to the correct
pressure. NEVER exceed the recommended tire
pressure specified in this Operator’s Manual.
ALWAYS keep the tractor securely supported while
changing the wheels or adjusting the wheel tread
width.
ALWAYS keep the wheel bolts tightened to the
specified torque.
Be careful to avoid injury:
●Do not mount a tire on a rim. Have a qualified
professional with the proper equipment mount the
tire on the rim.
●Always keep the correct tire pressure. Do not
exceed the recommended tire pressure specified in
the operator's manual.
IMPORTANT:
●Only use the tires approved by Cub Cadet Yanmar
dealers.
Three tire sizes are provided for the front wheels of the Cub
Cadet Yanmar tractor and another three tire sizes are
available for the rear wheels. The recommended tire air
pressures for these tires are as specified in the table below.
Remember that tire air pressure gradually decreases as
time elapses. Check the pressure of each tire before
starting the day's operation and inflate the tires as
necessary to the recommended pressures. If the tire air
pressures significantly decrease though the tires are
correctly inflated every day, immediately request your
local Cub Cadet Yanmar dealer to inspect or replace the
problem tire(s).
WARNING
1. Tires
WARNING
To Next Page
Loading...
Need help?
General