16-3
16. STORAGE
Ex2900 / 3200 Operator's Manual
1. Check the tire pressure. If necessary, refill with compressed air.
2. Check the levels of engine oil, transmission/hydraulic oil and engine
coolant.
3. Check the battery electrolyte level.
4. Check that the battery is adequately charged.
5. Install the battery.
6. Check the fan belt tension.
7. Lubricate all the grease fittings.
8. If the tractor has a fuel shut-off valve, open it.
9. Run the engine for 5 minutes while the mower or any implement is
disengaged to allow the oil to be fully distributed throughout the entire
engine. After stopping the engine, walk around the tractor and check for
any evidence of oil or other leakage.
10. Make sure that all the shields, guards or deflectors are in place.
2. Preparing the Stored Tractor for Operation
To Next Page
Loading...
Need help?
General