Culligan GBE - Page 28

7. Set Hour
Set hour
7
• If the value displayed is NOT correct, pressing the “CHECK MARK” button will change the display, to show
a “>” symbol next to the displayed value. Use the UP or DOWN arrow to change the setting. Once the
desired value is displayed, this value can be accepted by pressing the “CHECK MARK” button.
Press the DOWN arrow to accept that value and move to the next question.
8. Set Minute
Set minute
32
• If the value displayed is NOT correct, pressing the “CHECK MARK” button will change the display, to show
a “>” symbol next to the displayed value. Use the UP or DOWN arrow to change the setting. Once the
desired value is displayed, this value can be accepted by pressing the “CHECK MARK” button.
Press the DOWN arrow to accept that value and move to the next question.
9. Set AM or PM
Set am or pm
7:32 am
• If the value displayed is NOT correct, pressing the “CHECK MARK” button will change the display, to show
a “>” symbol next to the displayed value. Use the UP or DOWN arrow to change the setting. Once the
desired value is displayed, this value can be accepted by pressing the “CHECK MARK” button.
Press the DOWN arrow to accept that value and move to the next question.
10. Set Valve Type (4-cycle or 5-cycle)
valve type
4-cycle
CSM and Hi-Flo 50 are 4-cycle valves and Hi-Flo 22 and Hi-Flo 3e are 5-cycle valves.
• If the value displayed is NOT correct, pressing the “CHECK MARK” button will change the display, to show
a “>” symbol next to the displayed value. Use the UP or DOWN arrow to change the setting. Once the
desired value is displayed, this value can be accepted by pressing the “CHECK MARK” button.
Press the DOWN arrow to accept that value and move to the next question.
First Time Setup Process
First Time Setup Process 26
25 CULLIGAN GLOBAL ELECTRONIC CONTROLLER