Driving
●
The camera lens e
xpands and distorts the
field of view and displays the objects on the
screen in a way that is different from reality.
Distance perception is also distorted.
●
Due to the screen resolution or light con-
ditions, some items may be blurry or not
displayed at all. Take care with thin posts,
fences, railings or trees that might not be
seen on the screen and could damage the
vehicle.
●
The reverse assist has blind spots where it
cannot see people or objects. Monitor the
vehicle's surrounding area at all times.
●
The system is not a replacement for driv-
er awareness. Supervise the parking ma-
noeuvre and the vehicle's surrounding area
at all times.
●
Do not be distracted from the traffic by
looking at the screen.
●
The images are only two-dimensional.
Protruding objects or holes in the road, for
example, are more difficult to detect or
may not be seen at all.
●
Vehicle load modifies the representation
of the guide lines. The width represented
by the lines decreases with vehicle load.
Pay special attention to the surroundings
when the inside of the vehicle of the lug-
gage compartment are loaded.
●
In the following situations, objects or
other vehicles appear to be further away or
closer than they actually are. Pay special
attention:
–
If moving fr
om a flat surface to a slope
and vice-versa.
–
If the vehicle is heavily loaded.
–
When the vehicle approaches objects
that are not on the ground surface or
that protrude from it. These objects
may be outside the camera angle when
reversing.
Note
●
It is important to take great care and pay
special attention if the driver is not familiar
with the system.
●
The reverse assist reference lines disap-
pear when the rear lid is open.
Introduction
A camera installed in the rear lid handle as-
sists the driv
er with r
everse parking or ma-
noeuvring
›››
page 234 .
The camera image is viewed together with
orientation lines projected on the Infotain-
ment system screen. Part of the bumper can
be seen at the bottom, which can be used by
the driver as a reference point.
Reverse assist modes
Depending on the equipment, the following
modes are available:
●
Angle parking: reverse parking perpendic-
ular to the road.
●
Assistance function for hitching a trailer:
helps to hitch a trailer.
●
Cross traffic: traffic is monitored in a trans-
verse direction.
Connecting and disconnecting
Connect the reverse assist
●
Select reverse gear.
●
OR: in the inf
ot
ainment system select >
Assistants > Park assist.
Disconnect the reverse assist
Drive forward at least 15 km/h (9 mph).
Shown on the display
The system’s functions and representations
ma
y v
ary depending on the equipment.
The assistant's image view changes when the
factory-fitted tow hitch is electronically con-
nected to a trailer
›››
page 295 .
Reverse assist functions and symbols
When the reverse assist is connected, you
can make adjustments using the function
286
To Next Page
Loading...
