Self-help
Rear towline anchorage
Fig. 45
On the right side of the rear bumper: re-
move the cover.
Fig. 46
On the right side of the rear bumper: tow-
line anchorage in position.
The housing of the screw towing eye is on
the right side of the r
e
ar bumper behind a lid
›››
Fig. 45.
Vehicles equipped as standard with a towing
bracket do not have any housing for the
screw towing eye behind the lid. In this case,
the tow hitch needs to be extracted or instal-
led and used for towing
›››
page 288 ,
›››
.
Be
ar in mind the instructions f
or towing
›››
page 54.
Assemble the rear towing eye (cars with-
out a factory-equipped towing bracket)
●
Remove the towing eye from the vehicle
tool kit in the luggage compartment
›››
page 43.
●
Press the upper side of the lid
›››
Fig. 45 to
unclip it.
●
Remove the lid and let it hang from the ve-
hicle.
●
Screw the towing eye in the housing by
turning it to the maximum anticlockwise
›››
Fig. 46
›››
. Use a suitable object that
can complet
ely and secur
ely tighten the
towing eye in its housing.
●
After towing, unscrew the towing eye
clockwise with a suitable object.
●
Replace the cover and press until the tab
snaps into the bumper.
●
Clean the towing eye if necessary and then
store it in the luggage compartment along
with the other vehicle tools.
CAUTION
●
The towing eye must always be complete-
ly and firmly tightened. Otherwise, it could
be released while towing and tow-starting.
●
If the vehicle is factory-equipped with a
towing bracket, it is only allowed to tow with
a tow bar if this has been specially designed
to be installed with a tow hitch. If an unsuit-
able tow bar is used, both the tow hitch and
the vehicle may be damaged. Instead, a tow
rope should be used.
57
To Next Page
Loading...
