22 | CURBTENDER, INC
EJECTING THE LOAD
1) Engage the PTO by turning the system on. This will start the hydraulic pump and enable the
engine acceleration circuit.
2) Raise the tailgate: Activate the engine accelerator switch; then pull outward on the rear
body valve lever until the tailgate is in the fully raised position.
3) Eject the load: Activate the engine accelerator switch; then pull outward on the forward body
valve lever until the load is ejected.
4) Pull the vehicle forward, retract the eject panel, and clean all debris from the body and tail-
gate.
ENSURE ALL INDIVIDUALS ARE CLEAR OF ANY MOVING
PARTS, MECHANISMS, OR COMPONENTS OF THE VEHICLE BE-
FORE ACTUATING CONTROLS. BE ATTENTIVE AT ALL TIMES AND PREPARED TO STOP FUNCTION.
USE A SPOTTER AND BE CAREFUL WHEN BACKING. MAKE
SURE THE TRUCK IS ON HARD, LEVEL GROUND AND LOOK
FOR OVERHEAD OBSTRUCTIONS BEFORE RAISING THE TAIL-
GATE. THIS IS NECESSARY TO PREVENT EQUIPMENT DAMAGE AND PERSONAL INJURY FROM THE TRUCK
TIPPING OVER.
NEVER DRIVE THE UNIT MORE THAN 10 FEET WITH THE TAIL-
GATE IN THE RAISED POSITION!
To Next Page
Loading...