Currie tech Izip E3 Path - Linear-Pull Brake Setup; Linear-Pull Brake Adjustment Procedure

74
75
3mmwasherB6mmwasherB
Washer A
Brake arm
Washer A
Washer
Shoe fixing nut
Boot
Cable Fixing Bolt &
Washers
Link Fixing Bolt
Shoe Fixing Nut
Washer
"B" Washer
"B" Washer
"A" Washer
Spring Tension
Adjustment Screw
"A" Washer
Linear-Pull Brakes
Brake Shoes
Brake Noodle
Linear-Pull Brake Setup
1. While holding the brake shoe against the rim, adjust the amount
ofshoeprotrusionbychangingoverwasherB(3mmor6mm)so
that dimension Aiskeptat32mmormore.more. Generally, you
will install the 6mm washer on the inside for narrow 700c wheels,
andthe3mmwasherontheinsideforwider26"wheels.
2. While holding the shoe against the rim, tighten the shoe fixing nut.
The brake shoe should be centered vertically on the rim.
3. Threadthebrakecablethroughthebrakenoodleandboot.
4. Settheclearancebetweenthebrakeshoesandtherimto~1mm
on each side and tighten the cable fixing bolt. This distance does
not need to be set exactly at the brake arm, as you can finely
adjust it more easily with the brake lever barrel adjustor (see
photo on page 72).
5. If the brake pads are not centered around the rim, you can adjust
the balance with the spring tension adjustment screws.
5mm Allen key
32mmormore
A
B
1mm
5mm Allen key
Brake Cable
Brake Noodle
Boot
1mm 1mm
Spring Tension
Adjustment Screw
Spring Tension
Adjustment Screw
1mm 1mm
1
2
11 22
1
2
5
3, 4