Currie tech Izip E3 Path - Final Checks and Maintenance Schedules; Final Pre-Ride Checks and Adjustments; Routine Maintenance Lubrication Schedule

87
86
Final Check
• Afteralladjustmentshavebeenmade,shiftthrough
every gear several times at varying speeds. This will
ensure all your adjustments are correct and will allow
you to pinpoint any trouble areas. If you encounter any
problems, refer to the appropriate section and make any
necessary adjustments.
• Checkthetirepressureandinflateeachtubetothe
recommended psi as stated on the sidewall of the tire.
• Checkthatthekickstandoperatessmoothlyandthe
kickstand bolt is secured tightly.
• Finally,examinethebicycle.Makesureallaccessories
are attached and all quick releases, nuts and bolts have
been tightened securely.
• Correctmaintenanceofyourbicyclewillensuremany
years of happy riding. Service your bicycle regularly by
referring to the relevant sections of this manual, OR
take it to a professional bicycle shop.
• Remember:Alwayswearahelmetandobeyalltraffic
laws.
Never inflate a tire beyond the maximum pres-
sure marked on the tire’s sidewall. Exceeding
the recommended pressure may blow the tire
off the rim, which could cause damage to the
bicycle and injury to the rider and bystanders.
Tighten both rear wheel axle nuts or the quick
release mechanism securely. Failure to do this
may cause the rear wheel to dislodge from the
frame dropouts resulting in serious damage
or injury.
!
!
Correct routine maintenance of your new bike will ensure smooth running - Longer
lasting components - Safer riding - Lower running costs
Every time you ride your bicycle, its condition changes. The more you ride, the more frequently maintenance will be required.
We recommend you spend a little time on regular maintenance tasks. The following schedules are a useful guide and by
referring to Part 6 of this manual, you should be able to accomplish most tasks. If you require assistance, we recommend you
see a bicycle specialist.
Schedule 1 - Lubrication
Note: The frequency of maintenance should increase with use in wet or dusty conditions. Do not over
lubricate-removeexcesslubricanttopreventdirtbuildup.Neveruseadegreasertolubricateyourchain(WD-40™)
PART 5 - SERVICING
Frequency Component Lubricant How to Lubricate
 Chain Chain Lube or Light Oil Brush On or Squirt
Derailleur Pulleys Chain Lube or Light Oil Brush On or Squirt
Derailleurs Oil Oil Can
Brake Calipers Oil 3dropsfromoilcan
Brake Levers Oil 2 drops from oil can
Monthly Shift Levers Lithium Based Grease Disassemble
Every Six Months Freewheel Oil 2 squirts from oil can
Brake Cables Lithium Based Grease Disassemble
Yearly Bottom Bracket Lithium Based Grease Disassemble
Pedals Lithium Based Grease Disassemble
Derailleur Cables Lithium Based Grease Disassemble
Wheel Bearings Lithium Based Grease Disassemble
Headset Lithium Based Grease Disassemble
Seat Post Lithium Based Grease Disassemble