EasyManua.ls Logo

Curtis 1244 - Page 8

Curtis 1244
96 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
2
Curtis 1244 Manual, Rev. E
1 — OVERVIEW
Like all Curtis motor controllers, the 1244 oers superior operator control of
the vehicle’s motor drive speed. Features include:
✓ Full-bridge field and half-bridge armature power MOSFET design,
providing
•infinitelyvariableforward,reverse,drive,andbrakecontrol
•silenthighfrequencyoperation
•highefficiency
✓ Regenerative braking, providing longer operation on a single battery charge
and reducing motor brush wear and motor heating
✓ Programmability through the 1313 handheld programmer and 1314 PC
Programming Station
✓ Complete diagnostics through the programmer and the internal Status LED
✓ Two fault outputs provide diagnostics to remotely mounted displays
✓ Continuous armature current control, reducing arcing and brush wear
✓ Automatic braking when throttle is reduced from either direction; this
provides a compression braking feel and enhances safety by automatically
initiating braking in an operator hands o condition
✓ Deceleration Rate, Load Compensation, and Restraint features prevent
downhill runaway conditions; speed is controlled to within approximately
20% of level surface value
✓ MultiMode™ allows four user-selectable vehicle operating personalities
✓ Programmable to match individual separately excited motor characteristics
✓ Meets or exceeds EEC fault detect requirements
✓ Vehicle top speed is controlled and limited in each mode
✓ Linear temperature and undervoltage cutback on motor currents; no sudden
loss of power under any thermal conditions
✓ High pedal disable (HPD) and static return to o (SRO) interlocks prevent
vehicle runaway at startup
✓ Creep speed adjustable from 0% to 25% in each mode
✓ Continuous diagnostics during operation, with microprocessor power-on
self-test
✓ Internal and external watchdog circuits ensure proper software operation
✓ Programmable coil drivers provide adjustable contactor pull-in and holding
voltages
✓ Hour-meter enable output is active whenever the controller is providing
motor current
✓ Optional Electromagnetic Brake Driver provides automatic control of an
electromagnetic brake or other similar function
✓ Optional Reverse Signal Driver provides a low signal any time the vehicle
is driving or braking in reverse

Table of Contents