User Guide DDOC0199-000-A9
1-Slot Data Transport System (CSfC) 6 - 14 Encryption
© 2024 Curtiss-Wright Defense Solutions Revision 3.0
2. Open the SWE container on partition 2 of a 100GB RMC module as follows:
Command:
rmcctl -p 2 -E passphrase1
If the passphrase is entered correctly the following message will be displayed:
RMC_C0; action=enter status=OK ‘Resetting attempts to 0’.
Example
3. Verify SWE containers are open.
Command:
rmcctl
If SWE container is open, osdm = 1
Example
6.4.2.3 Initialize SWE Encryption (Partitions - Same Passphrase)
CAUTION
DATA LOSS. Initializing the software encryption layer will overwrite / destroy any existing data on
the partition. As a result, the --force option must be used.
Initialize the SWE containers on all partitions of a 100GB RMC module as follows:
1. Partition drive. Refer to paragraph 8.5.1 Preparation for Partition and paragraph 8.5.2
Partition Disk for information.
2. Type rmcctl -p all --force -C and press E
NTER key.
NOTE
After the above command has be issued, the user must acknowledge that all data on the partition
will be overwritten
3. At the overwrite query prompt type YES and press E
NTER key.
NOTE
Refer to paragraph 6.1.2 Software Layer Passwords / Passphrases for requirements.
4. Enter a password / passphrase that complies with the password / passphrase requirements
and press E
NTER key.
5. Reenter the password / passphrase and press E
NTER key.
If the passphrase is entered correctly both times and meets the requirements the following
message will be displayed: RMC_C0; action=cryp status=OK.
Example
6. Verify SWE container is initialized.
cw_dts> rmcctl -p 1 -E passphrase2
[rmcctl]
RMC_CO; action=enter status=OK ‘Resetting attempts to 0’
[!rmcctl] OK
cw_dts> rmcctl
[rmcctl]
RMC_S#: ins hcryp osdr p# size serv scryp osdm fmt mnt rem mntpoint
*********************************************************************************
RMC_S0: 1 1 1 1 50 GB NAS 1
1 0 0 0 rmc0p1
RMC_S0: 1 1 1 2 50 GB NAS 1 1 0 0 0 rmc0p2
[!rmcctl] OK
cw_dts> rmcctl -p all --force -C password / passphrase
[rmcctl]
Please verify password: password / passphrase
RMC_CO; action=cryp status=OK
[!rmcctl] OK
To Next Page
Loading...