Cutter Case
1
Disconnect the power supply cable and
open the device (see previous paragraphs).
Disconnect the power supply cable
(see previous paragraphs).
2
Remove any scraps of paper and the
accumulated paper dust on the input
and the output of cutter.
To clean the device,
use compressed air or a soft cloth.
1
2
ATTENTION:
Do not use alcohol, solvents, or hard brushes.
Do not let water or other liquids get inside the machine.
ON
Alcohol, solvent
ATTENTION:
Do not use alcohol, solvents, or hard brushes.
Do not let water or other liquids get inside the machine.
ON
Alcohol, solvent
43
To Next Page
Loading...