Need help?Do you have a question about the Custom Audio Electronics TL60 and is the answer not in the manual?
General| Brand | Custom Audio Electronics |
|---|---|
| Model | TL60 |
| Category | Label Maker |
| Language | English |
Lists all the components included in the device packaging for verification.
Identifies and labels the various parts and connectors of the device.
Explains the information found on the device's product label.
Details the functions of the device's keys during the power-on sequence.
Explains the functions of the device's keys when in standby mode.
Describes the meaning of different LED signals and device status.
Provides instructions and dimensions for physically mounting the device.
Details the procedure for assembling and positioning the paper roll holder.
Illustrates the possible cable connections for the device.
Specifies the pin configurations for the power supply and USB interfaces.
Information on obtaining and installing device drivers and SDKs.
Step-by-step guide on how to open the device for access.
Instructions on how to properly close the device after operation.
Details on how to adjust the paper roll width setting.
Procedure for connecting power and turning the device on.
Instructions for loading a new paper roll into the device.
Explains different modes for printing and ejecting tickets.
Steps to enter the device's configuration or setup mode.
Details and explanation of the printer's setup report contents.
Information displayed in the printer status configuration print-out.
Lists and describes the various configurable parameters for the printer.
Function for diagnosing received characters via the communication port.
Procedure for clearing paper jams from the device.
Recommended schedule and methods for cleaning device components.
Detailed instructions for cleaning rollers, cutter, and printer case.
Step-by-step guide for updating the device's firmware.
Technical details covering sensors, interfaces, memory, and printer resolution.
Details about character set, density, number of columns, and lines per second.
Provides physical dimensions and weight for the device models.
Specifies the physical dimensions of the optional power supply unit.
Details on paper requirements, including black mark placement.
Lists and shows the available character sets and their code tables.
Explains the automatic sensor calibration process for black mark detection.
Defines alignment point and B. Mark Distance settings.
Discusses how to calibrate printing area based on black mark distance.
To Next Page
