7.3 Cleaning
For periodic cleaning of the device, see the instructions below
Rollers Paper path
ISOPROPYL ALCOHOL
Disconnect the power supply cable and
open the device (see previous paragraphs).
Disconnect the power supply cable and
open the device (see previous paragraphs).
Remove any scraps of paper and the
accumulated paper dust on the rubber roller and in
areas near to the paper presence sensor.
Clean the printing roller by using
a non-abrasive cloth moistened with isopropyl.
ATTENTION:
Do not use solvents, or hard brushes.
Do not let water or other liquids get inside the device.
ON
ATTENTION:
Do not use alcohol, solvents, or hard brushes.
Do not let water or other liquids get inside the device.
ON
Alcohol, solvent
1
2
1
2
62
To Next Page
Loading...