6.4 Printer parameters
The parameters marked with the symbol
D
are the default values.
Settings remain active even after the printer has been turned off and they are stored in non-volatile memory.
PRINTER EMUL Available emulations for the device:
ESC/POS
D
TG2460
NOTE: This parameter is printed only for TL60 models.
BAUD RATE Communication speed of the serial interface:
115200
D
19200 2400
57600 9600 1200
38400 4800
NOTE: Parameter valid only with serial interface.
DATA LENGTH Number of bit used for characters encoding:
7 bits/car
8 bits/car
D
NOTE: Parameter valid only with serial interface.
PARITY Bit for the parity control of the serial interface:
None
D
= parity bit omitted
Even = even value for parity bit
Odd = odd value for parity bit
NOTE: Parameter valid only with serial interface.
HANDSHAKING Handshaking:
XON/XOFF
D
NOTES:
Parameter valid only with serial interface.
When the receive buffer is full, if handshaking is set to XON/XOFF, the printer sends the XOFF (0x13) on the
serial port. When the receive buffer has cleared once again, if handshaking is set to XON/XOFF, the printer
sends the XON (0x11) on the serial port.
BUSY CONDITION Activation mode for Busy signal:
the buffer is full
D
NOTE: Parameter valid only with serial interface.
52
To Next Page
Loading...
Need help?
General
