Custom Audio Electronics TL60 - Page 63

Cutter Case
Disconnect the power supply cable and
open the device (see previous paragraphs).
Disconnect the power supply cable
(see previous paragraphs).
Remove any scraps of paper and the
accumulated paper dust on the input
and the output of cutter.
To clean the device,
use compressed air or a soft cloth.
ATTENTION:
Do not use alcohol, solvents, or hard brushes.
Do not let water or other liquids get inside the device.
ON
Alcohol, solvent
ATTENTION:
Do not use alcohol, solvents, or hard brushes.
Do not let water or other liquids get inside the device.
ON
Alcohol, solvent
ISOPROPYL ALCOHOL
1
2
1
2
63