6.3 Cleaning
For periodic cleaning of the device, see the instructions below.
Rollers Paper path
ATTENTION:
Do not use solvents, or hard brushes.
Do not let water or other liquids get inside the machine.
ON
ISOPROPYL ALCOHOL
1
Disconnect the power supply cable and
open the device (see previous paragraphs).
2
Clean the printing roller by using
a non-abrasive cloth moistened with isopropyl.
Disconnect the power supply cable and
open the device (see previous paragraphs).
Remove any scraps of paper and the
accumulated paper dust on the platen roller and
in areas near to the paper presence sensor.
1
2
ATTENTION:
Do not use alcohol, solvents, or hard brushes.
Do not let water or other liquids get inside the machine.
ON
Alcohol, solvent
42
To Next Page
Loading...