Technical Reference Manual
Page 28 of 38
PT-3000
2.1.4 Power Management Setup Menu
ROM PCI/ISA BIOS <2A5IIAKA>
POWER MANAGEMENT SETUP
AWARD SOFTWARE, INC.
Power Management: Enabled
PM Control by APM: Yes
Video Off Option: Susp,Stby Off
Video Off Method: DPMS supported
Doze Speed (div by): 2
Stdby Speed (div by): 2
MODEM Use IRQ: 3
Hot key Suspend: Disabled
** PM Timers **
HDD Off Afte: Disable
Doze Mode: Disable
Standby Mod: Disable
Suspend Mode: Disable
** PM Events **
COM Ports Activity: Enabled
LPT ports Activity: Enabled
HDD Ports Activity: Enabled
VGA Activity: Disabled
3 <COM 2> :Enabled
IRQ4 <COM 1> :Enabled
IRQ5 <LPT 2> :Enabled
IRQ6 <Floppy Disk>:Enabled
IRQ7 <LPT 1> :Enabled
IRQ8 <RTC Alarm> :Disabled
IRQ9 <IRQ2 Redir> :Enabled
IRQ10<Reserved> :Enabled
IRQ11<Reserved> :Enabled
IRQ12<PS/2 Mouse :Enabled
IRQ13<Coprocessor> :Enabled
IRQ14<Hard Disk> :Enabled
IRQ15<Reserved> :Enabled
Esc :Quit :Select Item
F1 :Help PU/PD/+/- :Modify
F5 :Old Value (Shift)F2 :Color
F6 :Load BIOS Defaults
F7 :Load Setup Defaults
There are four selections for Power Management:
Disable No power management. Disable all four modes.
Min. Power
Saving
Minimum power management, Doze mode = 1 hr. Standby
Mode = 1 hr. Suspend Mode = 1 hr. and HDD Power Down =
15 min.
Max.
Power
Saving
Minimum power management – ONLY AVAILABLE FOR SL
CPU’s, Doze mode = 1 min. Standby Mode = 1 min. Suspend
Mode = 1 min. and HDD Power Down = 1 min.
User
Defined
Allows you to set each mode individually. When not disabled,
each of the ranges are from 1 min. to 1 hr. except for HDD
Power Down which ranges from 1 min. to 15 min. and
disable.
PM Control by APM: When enabled, an Advance Power Management device will be
activated to enhance the Max. Power Saving mode and stop the CPU internal clock. If
the Max. power saving is not enabled, this will preset to “No”. Default is “Yes”
Video off Method: This determines the manner in which the monitor is blanked
V/H
SYNC+Blan
k
This section will cause the system to turn off vertical and
horizontal synchronization ports and writes blanks to the
video buffer.
Blank
Screen
This option only writes blanks to the video buffer
DPMS Initial display power management signaling (default)