Network Setup
125
Check Enable Traffic Shaping, select a Default priority and click Submit to enable this
feature. The Default priority is assigned to all network services other than those
specifically added below.
To add a service, click New then New again. Select the Protocol and Port on which this
service runs. Select Priority for this service click Finish.
IPv6
Check Enable IPv6 to enable IPv6 routing and packet filtering. Support for IPv6 is
currently limited.
Note
You must also enable IPv6 for each connection that supports IPv6. See the section
entitled Direct Connection towards the beginning of this chapter.
When IPv6 is enabled, site-local addresses are assigned to LAN connections, the site-
local DNS server address (fec0:0:0:ffff::1/64) is assigned to LAN connections if
the DNS proxy is enabled, router advertisements are sent on LAN connections and 6to4
tunnels are created on Internet connections.
Additionally, a default set of IPv6 packet filter rules are enabled. These rules are
stateless (as opposed to the IPv4 packet filter rules which are stateful). The default rules
only support a single LAN connection and a single WAN connection. These rules may be
customized, refer to the Custom Firewall Rules section of the chapter entitled Firewall.
To Next Page
Loading...
Need help?
General
