Network Setup
109
access-list local_nets deny any
! Our AS number
router bgp 1
! Our IP address
bgp router-id 192.168.0.1
! Announce our own network to other neighbors
network 192.168.0.0/24
! Advertise all connected routes (directly attached interfaces)
redistribute connected
! Advertise kernel routes (manually inserted routes, IPSec)
redistribute kernel
! Every 'router bgp' block contains a list of neighbors to
which the router is connected:
neighbor 192.168.1.1 remote-as 2
neighbor 192.168.1.1 distribute-list local_nets in
neighbor 10.10.1.1 remote-as 3
neighbor 10.10.1.1 distribute-list local_nets in
Restart route management to enable the updated configuration – uncheck Enable route
management, click Update, check Enable route management and click Update.
If you prefer, you can uncomment the password and enable password lines, and then
telnet to the relevant ports to configure Zebra and/or ospfd via the command line. The
command line interface is very similar to the Cisco IOS interface. If you are familiar with
this, you may prefer to configure using this method.
System
To configure the CyberGuard SG appliance’s network system settings, click the System
tab on the Network Setup page. These settings control the CyberGuard SG appliance’s
identity on the network.
Hostname
The Hostname is a descriptive name for the CyberGuard SG appliance on the network.
It is also used as the SNMP sysName field. By default, this is set to the model name of
your CyberGuard SG appliance, e.g. SG710.
To Next Page
Loading...
Need help?
General
