Virtual Private Networking
214
Tunnel List
Connection
Once a tunnel has been configured, an entry with the tunnel name in the Connection
field is shown.
Note
You may modify, delete or disable/enable a tunnel by clicking on the corresponding Edit,
Delete or Enable/Disable icon.
Remote party
The Remote Party which the tunnel is configured to connect to is defined either by its
Endpoint ID, IP Address or Distinguished Name.
Click Remote Party to sort the tunnel list by the remote party ID/name/address.
Status
Tunnels that use Automatic Keying (IKE) display one of four states in the Status field.
The states include the following:
To Next Page
Loading...
Need help?
General
