Firewall
127
Administration services
The following figure shows the Administration Services page:
By default the CyberGuard SG appliance runs a web administration server, a Telnet and
an SSH service. Access to these services can be restricted to specific interfaces.
Typically, access to the web management console (Web/SSL Web) is restricted to hosts
on your local network (LAN Interfaces).
Disallowing all services is not recommended, as this makes future configuration changes
impossible unless your CyberGuard SG appliance is reset to the factory default settings.
Warning
If you do want to allow administrative access on interfaces other than LAN Interfaces,
there are several security precautions you should take. See the note in the next section
for details. Also consider remote administration using a VPN connection as an alternative
to opening a hole in the firewall, PPTP in particular is well suited to this task.
To Next Page
Loading...
Need help?
General
