Getting Started
35
Select Use the following IP address and enter the following details:
IP address: 192.168.0.100
Subnet mask: 255.255.255.0
Leave the Default gateway and DNS server addresses blank.
Set up the CyberGuard SG appliance’s password and network connection settings
Launch your web browser and navigate to 192.168.0.1.
Select Network Setup from the Networking menu.
A log in prompt is displayed. Enter the initial user name and password for the
CyberGuard SG appliance:
User name: root
Password: default
Note
If you are unable to connect to the management console at 192.168.0.1, or the initial
username and password are not accepted, press the Reset button on the CyberGuard
SG appliance’s rear panel twice, wait 20 – 30 seconds, and try again.
To Next Page
Loading...
Need help?
General
