42
Press the Lock-o down, until it locks into
place as shown.
If Lock-o does not lock, try loosening the
LATCH strap slightly.
Grab the Base at the Belt Guides and pull from
side to side and front to back to make sure the
base is installed correctly. The base should not
move more than 1 inch (2.5 cm) in any direction.
If the Base moves too much, open the Lock-
o, tension the LATCH Strap a little more and
try again. After this, if the Base still moves too
much, you may need to try a dierent vehicle
seat location or installation method, or both.
Install load leg, see page 36.
8
9
INSTALLING THE BASE USING LATCH
8
9
CLICK!
To Next Page
Loading...
