Complete installation
1. Plug the power cord into the power outlet.
2. Verify the power cord is not being pinched under the front of the treadmill.
3. Operate the unit at all levels to verify proper operation.
Deck Pivot and Deck Bumpers
Tools Required:
• Phillips screwdriver
• Flat head screwdriver
• 5/32” Allen wrench
• 1/2” Socket wrench
• 9/16” Socket wrench
• 3/4” Socket wrench
Disconnect power source
1. Toggle the on/off (I/O) power switch to the off (O) position. The on/off (I/O) power switch is located
under the front end of the unit, or on the front right side panel.
2. Unplug the treadmill from the power outlet.
Shock and electrocution hazard.
• Unplug unit and let sit 10 minutes before cleaning or performing
maintenance.
• Electrical charge can remain in unit after unplugging.
• Keep water and liquids away from electrical parts.
Remove end caps
1. Remove two screws securing right end cap using a Phillips screwdriver.
Qty.DescriptionItem
1Right end cap1
2Screws2
2. Repeat step for left end cap.
Page 128 of 199
Cybex 525T Treadmill Part Number
To Next Page
Loading...
Need help?
General
