CYBEX 770T - Page 207

2. Unplug control board cable and Audio Visual cable from the E3 View monitor.
Qty.DescriptionItem
1Control board cable1
1A/V cable2
1Coax cable3
3. Unscrew the coax cable from the E3 View monitor.
4. Remove the ground cable from the E3 View monitor using an 11/32” nut driver.
Qty.DescriptionItem
1Console Assembly1
1E3 View Monitor2
9Screw3
1Ground wire screw4
5.
Component damage. Do not touch front of E3 View Monitor. Oil from
fingertips will mark screen.
Remove the nine screws securing the E3 View Monitor to the console using a Phillips screwdriver.
Install E3 View Monitor
1.
Component damage. Do not touch front of E3 View Monitor. Oil from
fingertips will mark screen.
Remove protective cover from new E3 View monitor screen and place on old E3 View monitor.
Page 207 of 261
Cybex 770T/790T Treadmill Part Number