2. Screw the headphone jack cable into the headphone jack cover and tighten by hand.
3. Plug the headphone jack cable into the connector J6.
Qty.DescriptionItem
1J61
1Headphone jack cable2
1Headphone jack cover3
2Screw4
1Handset5
4. Install the two screws securing the headphone jack cover to the handset cover using a Phillips
screwdriver.
Complete installation
1. Plug the power cord into the power outlet.
2. Verify the power cord is not being pinched under the front of the treadmill.
3. Operate the unit at all levels to verify proper operation.
Handset
Tools Required:
• Phillips screwdriver
• ESD (Electrostatic Discharge) grounding strap
Disconnect power source
Unplug the power cord from the power outlet.
Shock and electrocution hazard.
• Unplug unit and let sit 10 minutes before cleaning or performing
maintenance.
• Electrical charge can remain in unit after unplugging.
• Keep water and liquids away from electrical parts.
Page 220 of 261
Cybex 770T/790T Treadmill Part Number
To Next Page
Loading...
