Complete installation
1. Plug the power cord into the power outlet.
2. Verify the power cord is not being pinched under the front of the treadmill.
3. Operate the unit at all levels to verify proper operation.
Contact Heart Rate Grips
Tools Required:
• Phillips screwdriver
• Needle nose pliers
• ESD (Electrostatic Discharge) grounding strap
Disconnect power source
Unplug the power cord from the power outlet.
Shock and electrocution hazard.
• Unplug unit and let sit 10 minutes before cleaning or performing
maintenance.
• Electrical charge can remain in unit after unplugging.
• Keep water and liquids away from electrical parts.
Remove handset assembly
1. Remove eight screws securing handset to console using a Phillips screwdriver.
Qty.DescriptionItem
1Handset assembly1
1Console2
8Screw3
Repairs and Service. Do not damage the wires or connectors when
installing or removing cables.
2. Use flashlight to locate cable connectors.
Page 239 of 261
Cybex 770T/790T Treadmill Part Number
To Next Page
Loading...
