CYBEX 770T - Page 238

Qty.DescriptionItem
1iPod Cable1
1
Access Cover (Shown for
reference)
2
1MCC Board3
1Connector4
5Notch5
Install handset assembly
1. Place handset assembly in position and plug in the following cables: graphics board (J12), handset
membrane (J9), contact heart rate grips (J7) and the ground wire.
Qty.DescriptionItem
1MCC board1
1Graphics board (J12)2
1Handset membrane (J9)3
1Contact heart rate grips (J7)4
2. Route iPod cable through notch in access cover.
3. Install eight screws securing handset assembly to console using a Phillips screwdriver.
Qty.DescriptionItem
1Handset assembly1
1Console2
8Screw3
Page 238 of 261
Cybex 770T/790T Treadmill Part Number