3.
Enter the sequence: .
4. Tap Setup at the main Toolbox screen.
5.
Tap the Shift Right icon to navigate to the TV Source icon.
6. Tap TV Source.
7. Select Tuner, STB + Tuner, or STB + HDMI from the A/V options. If STB + HDMI was selected,
skip tuning steps.
8.
Tap the Toolbox icon to return to the Toolbox screen.
9. Press the STOP key to exit Setup options.
MYE CableSAT Commander Receiver Programming
The MYE CableSAT Receiver (at the Set Top Box) will need to be configured to work with your facilities’
Set Top Box. The default setting works with most AT&T boxes. To change the setting, perform the
following procedure.
1. Start with MYE CableSAT Command Receiver power disconnected.
2. Using a pen or paperclip, press PGM switch and hold it pressed.
3. Connect power to MYE CableSAT Command Receiver.
4. Continue to hold PGM switch until power and learn LED's are lit solid (the first two LED's) then
release.
5. Press the PGM button until LED's light up in the pattern that corresponds with your Set Top Box:
COX Mi-
ni Box
DISHTime
Warner,
COX,
WOW
Verizon,
Charter
(Arris)
Direct
TV
Com-
cast
AT&T,
Uverse
Learned
Preset
Auto
Learn
Mode
LED
name
power
learn
pro-
grammed
error
6. When done, press and hold the PGM button until the red LED lights, then release. All LED's should
blink once as confirmation this configuration is now stored.
If none of the pre-configured codes above work with your Set Top Box, the MYE CableSAT Command
Receiver can be programed as a learning remote using the Infrared Remote Control provided with your
STB. Perform the following procedure MYE CableSAT Commander Receiver Auto Learn.
MYE CableSAT Commander Receiver Auto Learn
1. Start with MYE CableSAT Command Receiver power disconnected.
Page 48 of 261
Cybex 770T/790T Treadmill Part Number
To Next Page
Loading...
