2. Using a pen or paperclip, press PGM switch and hold it pressed.
3. Connect power to MYE CableSAT Command Receiver.
4. Continue to hold PGM switch until power and learn LED's are lit solid (the first two LED's) then
release.
5. Point remote control at red IR window on the side of the MYE CableSAT Command Receiver and
press Channel Up key on remote control. The learn LED will flicker and the programmed LED will
briefly light solid once command has been learned. Wait for learn LED to be solid.
6. Press Channel Down key on remote control. The learn LED will flicker and programmed LED will
briefly light solid once the command has been learned. All LED's should blink once as confirmation.
E3 View Monitor Setup
Access Setup Screen
Press and hold Cybex logo for 6 seconds to access
Screen Lock and Toolbox.
CYBEX LOGO
Press and hold language logo for 6 seconds to ac-
cess Screen Lock and Toolbox.
LANGUAGE ICON
1. Tap the Access Toolbox icon to display the Access to Toolbox login screen.
2.
Enter the sequence: .
3. Tap the Setup icon to display the Setup menu.
4.
Tap the Shift Right icon to navigate to the EPEM Setup icon.
5. Tap the EPEM Setup icon.
6.
Tap the Setup icon to advance to the SETUP MODE screen.
Follow procedure to setup the E3 View Monitor.
Picture
Channels
Features
OSD Language
Page 49 of 261
Cybex 770T/790T Treadmill Part Number
To Next Page
Loading...
