Assembly and Set Up
Page 2-2
Cybex Arc Trainer 750A/750AT Owner’s Manual
Unit Assembly
Tools Required
• Phillips screwdriver
• Torque wrench
• 3/16” Allen wrench (supplied)
• 7/32” Allen wrench (supplied) (2)
• 9/16” Open-end wrench
NOTE: The words “left” and “right” denote the user’s orientation.
1. Read and understand all instructions thoroughly before assembling unit.
2. Verify correct package.
Read box label to verify the model number and voltage (optional) match what was ordered.A.
Lift and remove cardboard sleeve surrounding unit.B.
Verify paint color matches what was ordered.C.
Verify correct voltage if option AC power kit is included.D.
3. Unpack and verify 750A contents of carton.
NOTE: For 750AT content verifi cation, skip to step 5.
See 750A content listing and Figure 1a for 750A carton contents. A.
Check off each item as found. See B. Customer Service – Chapter 5 for contact information if any
parts are missing.
750A Contents
Item Qty Part Number Description
1 1 Varies Base with covers attached
2a 1 Varies Console assembly (in box)
2b 1 750A-124 Handrail assembly
3 2 12090-322 Foot pad
4 1 740A-370 Tray, Main
5 1 740A-371 Tray, Insert
6
1 NA Hardware pack
7 1 5750-4 Owner’s Manual
8 1 750A-402 Assembly poster
9 1 750A-391 Commercial Arc warranty sheet
10 1 750A-392
Consumer Arc warranty sheet
To Next Page
