Cybex Arc Trainer 750A/750AT Owner’s Manual
Maintenance
Page 4-4
Every 5000 Miles (8000 KM)
Check drive belts for tension and wear. (See procedure First 500 Miles)
Move unit and vacuum underneath. Lift the rear of unit and roll it back from its present
position. Vacuum underneath and return unit to normal position.
Clean inside unit.
1. Remove access cover. (See previous procedure Remove Access Cover)
2. Using a vacuum cleaner attachment or hand vacuum, clean the exposed components.
3. Remove dirt and debris from internal components.
4. Using a dry cloth, wipe all exposed areas.
5. Attach access cover. (See procedure Attach Access Cover)
Every 20,000 Miles (32000 KM)
Contact qualifi ed service technician to check elevation assembly, replace any worn parts and lubricate
elevation bushings.
Statistics
The Statistics screen allows tracking of equipment usage.
Open Statistics screen from Count Down, Lock, CSAFE ID Entry or Dormant Modes
Press Clear, key in 9-9-9 and press ENTER.
Data features can also be accessed from the CSAFE port.
Use the ENTER key to advance to next screen.
Use the RESISTANCE keys to scroll forward or backward in the menu.
Statistics Menu Display
ST1 – ODOMETER KM XXXX.X or
MI XXXX.X
0.0 – 999,999.9 (X=total accumulated miles or KM)
ST2 – HOURS HOURS XXXXXX 0 – 99999 (X=total user session time)
ST3 – STARTS STARTS XXXXXX 0 – 999,999 (X=total number of user sessions)
ST4 – MOVES MOVES XXXXXX 0 – 9,999,999 (X=number of incline moves in 1% increments)
ST5 – BATTERY BATTERY XXXXXX 0 – 999,999 (X=total whole minutes the battery has been used)
ST6 – ERRORS X ERR X HH:MM
M-DD-YY
Tracks error codes in a rolling log of 20 entries, each stamped
with time and date
ST7 – PROGRAM
USAGE
PR Y XXXXXX Y= program number
XXXXX=number of times program was chosen, set completed
and unit entered active mode.
Clear data by holding Pause/End key for three seconds, listen for double beep, and press CLEAR.
To Next Page
Loading...
Need help?
General
