Operation
Page 3–12
Cybex 750A/750AT Arc Trainer Owner’s Manual
Alarm Set
To set up an alarm to sound during workout:
1. Press key #8 on the keypad, also labeled with an alarm clock icon. Text Area will display “ALARM
AT HH:MM Y”. Initially, this display refl ects actual time.
2. Use keypad to enter a direct time. Press the ENTER key after each entry to accept and move
forward.
HH (Hour) MM (Minutes) Y=A (AM) or P (PM)
NOTE: The +/- RESISTANCE control keys are also active to scroll the blinking time value up or down. Hold
down key to accelerate rate of increment.
Once alarm is set, the solid blue LED will light on the ENTER key. To cancel the alarm before it sound, press
#8 ALARM key once.
Once alarm time occurs, the display will show “ALARM” and start beeping. Press the CLEAR, ENTER or
#8 ALARM key to reset.
Battery Sentry
Battery Sentry uses display feedback (speed signal, key presses and heart rate) to determine user presence.
If a user is not detected within 20 seconds, the display beeps and inquires “ARE YOU THERE?”.
Resume striding, grab the contact heart rate grips or press any key within a pre-selected time to resume
workout.
To Next Page
Loading...
Need help?
General
