CYBEX ATON 2 User Manual

Handle Positions
The Handle has four LOCKED positions:
1. DRIVE and CARRY
2. 1ST LOADING POSITION
3. 2ND LOADING POSITION
4. RESTING
To move handle to a new position, squeeze BOTH Handle Adjustment Buttons
a
(one on each side) while rotating handle
b
.
BOTH Adjustment Buttons must be depressed at the same time in order
for the handle to move.
Using the Designer Canopy™
Simply pull forward to extend the Aton 2 Canopy. The Canopy has two
positions as shown.
To retract the Canopy, gently push it back into its original position.
WARNING!
DEATH or SERIOUS
INJURY can occur
• ALWAYS have the handle LOCKED in the DRIVE/CARRY position while
using this child restraint in a vehicle.
• ALWAYS verify that the handle is LOCKED in the DRIVE/CARRY position
before lifting Infant Carrier by the handle. An unlocked handle could
move unexpectedly, causing child to fall out.
• ALWAYS KEEP your child properly secured in the Harness even when
using the carrier outside of the vehicle.
• NEVER HANG toys or other objects from handle when using child
restraint in a vehicle as they could seriously injure a child in a sudden
stop or crash.
17
1
2
2
3
4
1
b
a
Using the Infant Carrier
English

CYBEX ATON 2 Specifications

General

Height Capacity	Up to 32 inches
Base Included	Yes
Side Impact Protection	Yes
Recline Positions	Multiple
Harness Type	5-point harness
Removable Cover	Yes, machine washable
Weight Capacity	4-35 lbs
Installation Type	LATCH, Seat Belt
Safety Standards	FMVSS 213
Installation	LATCH system or seat belt
Base Compatibility	Compatible with CYBEX Aton Base 2
Stroller Compatibility	Compatible with CYBEX strollers
Additional Features	Linear Side-impact Protection (L.S.P. System)