CYBEX ATON 2 User Manual

Attaching Infant Carrier to Base
1. Make sure handle is LOCKED in the DRIVE/CARRY position.
2. Lift Infant Carrier by the Handle and slide the Attachment
Rod under the Attachment Catch on the Base.
3. Rotate foot end of the Infant Carrier down onto
the Base until an audible
is heard.
The GREEN Safety Button will pop out from the middle of the Infant
Carrier Release to indicate proper attachment.
The Aton 2 is allowed to touch the vehicle seat(s) in front of it, as long
the recline angle of the Aton 2 is not affected.
WARNING!: To avoid DEATH or SERIOUS INJURY, ALWAYS have the
handle LOCKED in the upright DRIVE/CARRY position while using this
child restraint in a vehicle.
Releasing Infant Carrier from Base
If used, lower the LSP device. See page 39.
1. Press GREEN Safety Button
a
in while pushing
the Infant Carrier Release down
b
.
2. Slightly tilt Infant Carrier toward front of vehicle. Grasp
Infant Carrier with both hands to lift off.
WARNING!: ALWAYS verify that the handle is LOCKED in the CARRY
position before lifting Infant Carrier by the handle. An unlocked handle
could move unexpectedly, causing child to fall out.
38
a
b
2
2
1
1
Using the Infant Carrier with the Base

CYBEX ATON 2 Specifications

General

Height Capacity	Up to 32 inches
Base Included	Yes
Side Impact Protection	Yes
Recline Positions	Multiple
Harness Type	5-point harness
Removable Cover	Yes, machine washable
Weight Capacity	4-35 lbs
Installation Type	LATCH, Seat Belt
Safety Standards	FMVSS 213
Installation	LATCH system or seat belt
Base Compatibility	Compatible with CYBEX Aton Base 2
Stroller Compatibility	Compatible with CYBEX strollers
Additional Features	Linear Side-impact Protection (L.S.P. System)