Adjusting the Harness Height
For proper use of the Infant Carrier, the Harness shoulder straps MUST be at
the correct height for your child.
1. Place child in Infant Carrier making sure their bottom
is in the seat, and their back is fully supported.
2. Identify the CLOSEST Harness Strap Slots that are
AT or BELOW your child's shoulders.
The Infant Insert can obscure the correct Harness Slot. Be sure to
identify the correct Harness Slot on the Carrier itself.
3. If the Harness Straps need adjusting, remove child and
turn the Infant Carrier over to locate the Splitter Plate.
Unhook one Shoulder Strap from the Splitter Plate .
Only adjust one strap at a time to have the other strap for reference.
4. From the front, pull the strap out of the slot,
Seat Cover, and Infant Insert (if used).
5. Re-thread through the Infant Insert (if used),
Seat Cover and correct Harness Slot.
6. Reattach strap to the Splitter Plate and repeat for the other strap,
ensuring that the strap is routed under the base attachment rod.
7. Check that Harness is free from twists and that it
can be tightened and loosened easily.
Periodically check for proper shoulder strap height as your child grows.
WARNING!
DEATH or SERIOUS
INJURY can occur
• NEVER REMOVE Harness or Harness components from Infant Carrier.
• DO NOT USE child restraint if any part of the Harness is damaged..
18
Side View
2
3
4
5
1
Using the Infant Carrier
To Next Page
Loading...
Need help?
General
