CYBEX ATON 2 - Adjusting the Recline Angle without the Base

It's very important for your child's safety that this child restraint be installed
at the correct angle.
Adjust Recline
Adjust the seat angle until the RED Level Line on the Infant Carrier is level
with the ground.
If you are having trouble achieving the proper recline angle:
1. Uninstall Infant Carrier.
2. Place a tightly rolled towel or pool noodle under the Infant Carrier,
where indicated. If on an aircraft, a tightly rolled airline blanket
may be placed under the Infant Carrier to adjust the angle.
3. Continue installation.
WARNING!
DEATH or SERIOUS
INJURY can occur
• DO NOT use this or any other child restraint with a premature, low birth
weight, or medically fragile infant, until after you have consulted with your
doctor. Some infants may have difficulty breathing or have other medical
problems when placed in a seated position.
• If the child restraint is TOO UPRIGHT, the child's head may fall forward
and cause breathing problems. If the child restraint is TOO RECLINED
crash protection will be reduced..
43
Line MUST be level
with ground when
installed without
Base
Line MUST be level
with ground when
installed without
Base
Line MUST be level
with ground when
installed without
Base
Adjusting the Recline Angle without the Base
English