CYBEX ATON 2 User Manual

7. Pull up on Harness Straps to snug around the child's
hips while holding the Harness Buckle in place.
8. Slowly pull the adjuster strap to tighten the Shoulder Straps.
A snug strap should not allow any slack. It lies in a relatively
straight line without sagging. It does not press on the child’s
flesh or push the child’s body into an unnatural position.
9. Position the center of the Chest Clip even with the
child's armpits. Make sure the Shoulder Pads do not
interfere with the placement of the Chest Clip.
If the Shoulder Pads don't allow a proper fit,they can be removed to
provide more space for the Chest Clip. Unsnap to remove.
10. Harness Pinch Test. To test for a properly tightened Harness, pinch
the shoulder strap. A snug Harness should not allow you to pinch
any slack when pinched between your thumb and forefinger.
To keep child warm, place a blanket over child and Infant Carrier, AFTER
you have properly secured and tightened Harness around your child.
WARNING!
DEATH or SERIOUS
INJURY can occur
• ALWAYS KEEP child properly secured in Harness.
• NEVER SECURE child in Infant Carrier dressed in a bulky garment or heavy
clothing..
21
7
8
9
10
Using the Infant Carrier
English

CYBEX ATON 2 Specifications

General

Height Capacity	Up to 32 inches
Base Included	Yes
Side Impact Protection	Yes
Recline Positions	Multiple
Harness Type	5-point harness
Removable Cover	Yes, machine washable
Weight Capacity	4-35 lbs
Installation Type	LATCH, Seat Belt
Safety Standards	FMVSS 213
Installation	LATCH system or seat belt
Base Compatibility	Compatible with CYBEX Aton Base 2
Stroller Compatibility	Compatible with CYBEX strollers
Additional Features	Linear Side-impact Protection (L.S.P. System)