CYBEX ATON 2 User Manual

Using SensorSafe
3. CYCLE THE SENSORSAFE CHEST CLIP.
Your SensorSafe Chest Clip is designed to “go to sleep” if left fastened for
more than 12 hours. To reset, or “wake up” the Chest Clip, unfasten then
re-fasten it. When you do this, the blue LED will flash two times. TO PRESERVE
BATTERY LIFE, ALWAYS STORE THE SENSORSAFE CHEST CLIP IN THE UNCLIPPED
POSITION.
4. DRIVE THE VEHICLE.
The SensorSafe Receiver is designed to respond after the vehicle has been
driven at 5 miles per hour or more.
5. PARK THE VEHICLE AND TURN OFF THE IGNITION.
Within 2 seconds of parking your vehicle and turning off the ignition you will
hear the SensorSafe reminder, alerting you that your baby is in the vehicle. If
you don’t hear the reminder tone, test your SensorSafe by following steps 1-5
again. Contact CYBEX at: 1-877-242-5676 or online at:
www.cybex-online.com if the reminder tone again fails to sound.
SensorSafe Receiver will also alarm if your child unclips the Chest Clip
after the vehicle has been driven at 5 miles per hour or more, but only
if the vehicle is on.
PLACE AT ARMPIT LEVEL
SENSOR
SAFE
53
English

CYBEX ATON 2 Specifications

General

Height Capacity	Up to 32 inches
Base Included	Yes
Side Impact Protection	Yes
Recline Positions	Multiple
Harness Type	5-point harness
Removable Cover	Yes, machine washable
Weight Capacity	4-35 lbs
Installation Type	LATCH, Seat Belt
Safety Standards	FMVSS 213
Installation	LATCH system or seat belt
Base Compatibility	Compatible with CYBEX Aton Base 2
Stroller Compatibility	Compatible with CYBEX strollers
Additional Features	Linear Side-impact Protection (L.S.P. System)