CYBEX ATON 2 User Manual

Using SensorSafe (Cont.)
CR2032
a
b
b
c
CR2032
2
1
4. Turn the male side of the Chest Clip over and loosen screws
with a small Phillips screwdriver. Remove the cover
a
.
5. Remove Circuit Board
b
from Chest Clip. Remove Battery
c
from Circuit Board. Replace Battery with new Panasonic™ **
CR2032 Lithium button cell Battery, as shown.
6. Place the Circuit Board with the new Battery in the
Chest Clip. Replace the Cover and tighten the screws.
This completes the battery replacement process.
7. If you have questions, please contact CYBEX at: 1-877-242-56761
or online at: www.cybex-online.com
4
5
** Trademarks are the property of their respective owners.
55
English

CYBEX ATON 2 Specifications

General

Height Capacity	Up to 32 inches
Base Included	Yes
Side Impact Protection	Yes
Recline Positions	Multiple
Harness Type	5-point harness
Removable Cover	Yes, machine washable
Weight Capacity	4-35 lbs
Installation Type	LATCH, Seat Belt
Safety Standards	FMVSS 213
Installation	LATCH system or seat belt
Base Compatibility	Compatible with CYBEX Aton Base 2
Stroller Compatibility	Compatible with CYBEX strollers
Additional Features	Linear Side-impact Protection (L.S.P. System)