46
4a
9a
10a
ADJUSTING THE LOAD LEG
Make sure that the load leg (4a) is fixed in the forward
position. Push the adjustment button (9a) upwards on the
load leg and press it to pull the load leg. Pull the load leg
(4a) out until it touches the vehicle floor. After this, pull the
foot out to the next locking position to ensure optimal force
transmission. The load leg indicator (10a) on the base will
show GREEN.
!
WARNING! The load leg (4a) must always be in direct
contact with the vehicle floor. There must be no objects
or spaces between the vehicle floor and the load leg.
If there are storage compartments in the floor of the
vehicle you must contact the vehicle manufacturer.
NOTE! Make sure that the base rests as flat as possible on
the car seat.
To Next Page
Loading...
Need help?
General
